Inspect, Apply Primer, Clean: The Key to Pre-Primed Parts

What are the correct steps after a PRE-PRIMED part has already been cleaned and inspected?

a) Clean, inspect, apply primer

b) Apply primer, inspect, clean

c) Inspect, clean, apply primer

d) Inspect, apply primer, clean

Answer:

The correct steps after a PRE-PRIMED part has been cleaned and inspected are to inspect the part, apply primer, and then clean it.

The correct steps after a PRE-PRIMED part has already been cleaned and inspected are:

1. Inspect the Part

First and foremost, you need to inspect the part to ensure it meets the quality standards. Check for any defects, imperfections, or areas that may need additional attention.

2. Apply Primer

Next, apply primer to the part. Primer provides a protective layer that enhances the adhesion of subsequent coatings or materials. Make sure to apply the primer evenly and according to the manufacturer's instructions.

3. Clean the Part

Finally, clean the part after applying the primer. This step is crucial to remove any contaminants or debris that may affect the adhesion of the primer or any following processes. Ensure the part is thoroughly cleaned before proceeding.

By following these steps in the correct sequence, you can ensure the PRE-PRIMED part is properly prepared for further processes or applications, and achieve the desired results.