The Preferred Knot for Joining Two Pieces of Webbing Together

Which is the preferred knot for joining two pieces of webbing together?

Select one:
a. Water knot
b. Half hitch
c. Figure-eight
d. Clove hitch

Final answer:

The preferred knot for joining two pieces of webbing together is the water knot.

Final answer:

The preferred knot for joining two pieces of webbing together is the water knot. It is a simple and secure way to join two webbing pieces together.

The preferred knot for joining two pieces of webbing together is the water knot. Also known as the tape knot or ring bend, the water knot is commonly used in rock climbing and other outdoor activities. It is a simple and secure way to join two webbing pieces together.

To tie the water knot, follow these steps:

  1. Overlap the ends of the two webbing pieces.
  2. Tie an overhand knot by passing one end of the webbing through the loop created by the other end.
  3. Repeat the process, but this time pass the other end of the webbing through the loop created by the first end.
  4. Tighten the knot by pulling on both ends and adjusting it until it is secure.

Remember to always test the knot to ensure it is properly tied before relying on it for safety.

← Determining maximum positive bending moment on aisi 1020 hot rolled steel beam Cobblestone roads a durable and timeless form of paving →